Article content Pyle’s PLCM7700 7-inch monitor with rearview licence plate camera. This advertisement has not loaded yet, but your article continues below. A better alternative is to use the vehicle’s licence-lamp wiring access point. If you’re leasing your current ride or you’re concerned about corrosion, you might want to think twice about puncturing the metal. Most kits recommend drilling a hole in the body metal near the rear licence plate to run the camera power or signal wire. Monitors also require a power source but this is easily achieved with a dash or console-mounted power-point plug-in. This power source is the 12-volt feed to the vehicle’s reverse lights, so that when the transmission is shifted into reverse, the camera is activated and the monitor displays the image. Even those that don’t require a signal harness between the camera and the monitor require a power signal to the camera. Here are a few things to consider if you’re going this route.įirst, there’s no such thing as a wireless rearview camera system.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |